Show Stpd - Extreme Networks ExtremeWare XOS Command Reference Manual

show stpd

show stpd {<stpd_name> | detail}
Description
Displays STPD settings on the switch.
Syntax Description
stpd_name
detail
Default
N/A.
Usage Guidelines
The command displays the following STPD information:
STPD name
●
STPD state
●
STPD mode of operation
●
Autobind mode
●
Rapid Root Failover
●
Tag
●
Ports
●
Active VLANs
●
Bridge Priority
●
Bridge ID
●
Designated root
●
STPD configuration information
●
You can create, configure, and enable one or more STPDs and use the
STP configurations. Use the
command to enable an STPD. If you have considerable knowledge and
stpd {<stpd_name>}
experience with STP, you can configure the STPD using the
default STP parameters are adequate for most networks.
If your STPD has the same name as another component, for example a VLAN, Extreme Networks
recommends that you specify the identifying keyword as well as the name. If you do not specify the
keyword, an error message similar to the following is displayed:
stpd
%% Ambiguous command:
In this example, to view the settings of the STPD Test, enter
ExtremeWare XOS 11.3 Command Reference
Specifies an STPD on the switch.
Specifies that STPD settings should be shown for each STPD.
create stpd <stpd_name>
"show Test"
show stpd
command to create an STPD. Use the
commands. However, the
configure stpd
.
show stpd Test
show stpd
command to display
enable
973