Show Ports Sharing - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Configuring Slots and Ports on a Switch

show ports sharing

show ports sharing
Description
Displays port load-sharing groups, or link aggregation groups (LAGs).
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
Output from this command displays the following information:
Config Master—The port that is configured as the master logical port of the link aggregation group
●
(LAG). This number is also the LAG group ID.
Current Master—In LACP, this is the port that is currently the LAG group ID, or master logical port
●
for the LAG.
Agg Control—This is the aggregation control for the specified LAG; it can be either static or LACP.
●
In LACP, it is the aggregation control for the specified LAG.
Ld Share Algorithm—The algorithm used for the link aggregation. The available link aggregation
●
algorithms vary among platforms; see the ExtremeWare XOS Concepts Guide for more information.
Ld Share Group—The specific ports that belong to each LAG, or the port numbers in the trunk. A
●
port can belong to only one LAG, either static or dynamic.
Agg Mbr—In LACP, this shows whether the port has been added to the aggregator or not; it will be
●
either Y for yes or - for no.
Link Status—This is the current status of the link
●
Link Up transitions—Number of times the link has cycled through being up, then down, then up.
●
Example
The following command displays link aggregation on the switch:
show ports sharing
The following is sample output from this command on the Summit X450 switch:
Load Sharing Monitor
Config Current
Master Master
==============================================================================
5
364
Agg Ld Share
Control Algorithm
5 LACP L2
L2
Ld Share Agg Link
Group Mbr Status
5 Y A
6 Y A
ExtremeWare XOS 11.3 Command Reference
Link Up
transitions
3
3