Configure Sharing Lacp System-Priority - Extreme Networks ExtremeWare XOS Command Reference Manual

configure sharing lacp system-priority

configure sharing <port> lacp system-priority <priority>
Description
Configures the system priority used by LACP for each LAG to establish the station on which end
assumes priority in determining those LAG ports moved to the collecting/distributing state of the
protocol. That end of the LAG with the lowest system priority is the one that assumes control of the
determination. This is optional; if you do not configure this parameter, LACP uses system MAC values
to determine priority. If you choose to configure this parameter, enter a value between 1 and 65535.
Syntax Description
port
priority
Default
N/A.
Usage Guidelines
The LACP uses the system MAC values to assign priority to one of the systems, and that system then
determines which LAG ports move into the collecting/distributing state and exchange traffic. That end
of the LAG with the lowest system priority is the one that assumes control of the determination. If you
wish to override the default LACP system priority for a specific LAG, use this command to assign that
LAG a specific LACP priority. Enter a value between 1 and 65535.
You must enable sharing and create the LAG prior to assigning this LACP priority.
To verify the LACP system priority, use the
To change the system priority you previously assigned to a specific LAG, issue the
lacp system-priority
entirely and use the LACP priorities, issue the
value of 0.
Example
The following command assigns LAG 10 an LACP system priority of 3:
configure sharing 10 lacp system-priority 3
History
This command was first available in ExtremeWare XOS 11.3.
ExtremeWare XOS 11.3 Command Reference
Specifies the master logical port for the LAG you are setting the priority for.
Enter the value you want for the priority of the system for the LACP. The range
is 1 to 65535; there is no default.
show lacp
using the new priority you want. To remove the assigned system priority
configure sharing lacp system-priority
configure sharing lacp system-priority
command.
configure sharing
using a
309