Unconfigure Sflow Collector - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Status Monitoring and Statistics

unconfigure sflow collector

unconfigure sflow collector {ipaddress} <ip-address> {port <udp-port-
number>}
Description
Unconfigures the sFlow collector.
Syntax Description
ip-address
udp-port-number
vrname
Default
The following values are the defaults for this command:
UDP port number—6343
●
Virtual router—VR-Mgmt (previously called VR-0).
●
Usage Guidelines
NOTE
The BlackDiamond 8800 family of switches and the Summit X450 switch do not support user-created VRs.
This command allows you to reset the specified sFlow collector parameters to the default values.
Both the commands
parameters to the default.
Example
The following command removes the collector at IP address 192.168.57.1:
unconfigure sflow collector ipaddress 192.168.57.1
History
This command was first available in ExtremeWare XOS 11.0.
578
{vr <vrname>}
Specifies the IP address of the collector to reset.
Specifies the UDP port.
Specifies which virtual router.
NOTE: The BlackDiamond 8800 family of switches and the Summit X450
switch do not support user-created VRs.
unconfigure sflow
and
unconfigure sflow collector
will reset the collector
ExtremeWare XOS 11.3 Command Reference