Configure Log Target Filter - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Status Monitoring and Statistics

configure log target filter

configure log target [console | memory-buffer | primary-msm | backup-msm |
nvram | session | syslog [all | <ipaddress> | <ipPort> {vr <vr_name>}
[local0 ... local7]]] filter <filter-name> {severity <severity> {only}}
Description
Associates a filter to a target.
Syntax Description
target
console
memory-buffer
primary-msm
backup-msm
nvram
session
syslog
all
ipaddress
ipPort
vr_name
local0 ... local7
filter-name
severity
only
Default
If severity is not specified, the severity level for the target is left unchanged. If a virtual router is not
specified, VR-Mgmt is used.
Usage Guidelines
NOTE
The BlackDiamond 8800 family of switches and the Summit X450 switch do not support user-created VRs.
470
Specifies the device to send the log entries.
Specifies the console display.
Specifies the switch memory buffer.
Specifies the primary MSM.
NOTE: This parameter is available only on modular switches.
Specifies the backup MSM.
NOTE: This parameter is available only on modular switches.
Specifies the switch NVRAM.
Specifies the current session (including console display).
Specifies a syslog remote server.
Specifies all of the syslog remote servers.
Specifies the syslog IP address.
Specifies the UDP port number for the syslog target.
Specifies the virtual router that can reach the server IP address.
NOTE: The BlackDiamond 8800 family of switches (formerly known as Aspen)
and the Summit X450 switch do not support user-created VRs.
Specifies the local syslog facility.
Specifies the filter to associate with the target.
Specifies the minimum severity level to send (if the keyword only is omitted).
Specifies that only the specified severity level is to be sent.
ExtremeWare XOS 11.3 Command Reference