Extreme Networks ExtremeWare XOS Command Reference Manual page 692

QoS Commands
BlackDiamond 10K switch only. If a port is in more than one virtual router, you cannot use the DiffServ
replacement feature. The default VLAN DiffServ examination mappings apply on ports in more than
one VR. If you attempt to configure replacing DiffServ information on a port that is in more than one
virtual router, the system returns the following message:
Warning: Port belongs to more than one VR. Port properties related to diff serv and
code replacement will not take effect.
Example
The following command specifies that a code point value of 5 should be used to replace the DiffServ
(TOS) bits in packets in QP2:
configure diffserv replacement qosprofile qp2 code-point 5
History
This command was first available in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.
692
ExtremeWare XOS 11.3 Command Reference