Start Process - Extreme Networks ExtremeWare XOS Command Reference Manual

start process

start process <name> {msm <slot>}
Description
Restarts the specified process on the switch.
Syntax Description
name
slot
Default
N/A.
Usage Guidelines
Use this command after you have stopped a process and you want to restart it. To stop a process, use
the
terminate process
You are unable to start a process that is already running. If you try to start a currently running process,
an error message similar to the following appears:
Error: Process telnetd already exists!
Depending on the software version running on your switch and the type of switch you have, you can
restart different or additional processes. To see which processes you can restart, enter
followed by [Tab]. The switch displays a list of available processes.
To display the status of ExtremeWare XOS processes on the switch, including how many times a process
has been restarted, use the
command.
ExtremeWare XOS 11.3 Command Reference
Specifies the name of the process to start. You can start the following
processes:
• exsshd (only available if you have installed the SSH module)
• lldp
• netLogin
• ospf
• snmpMaster
• snmpSubagent
• telentd
• thttpd
• tftpd
Specifies the MSM where the process should be started. A specifies the MSM
installed in slot A, and B specifies the MSM installed in slot B.
NOTE: This parameter is available only on modular switches.
command.
show process {<name>} {detail} {description} {slot <slotid>}
start process
start process
275