Configure Meter - Extreme Networks ExtremeWare XOS Command Reference Manual

configure meter

configure meter <metername> {max-burst-size <burst-size> [Gb | Kb | Mb]}
{committed-rate <cir-rate> [Gbps | Mbps | Kbps]} {out-actions [drop | set-
drop-precedence {dscp [none | <dscp-value>]}}
Description
Configures an ACL meter.
Syntax Description
metername
max-burst-size
committed-rate
out-actions
drop
set-drop-precedence
dscp
none
Default
By default, a newly committed meter has no maximum burst size, no committed rate, and a default
action of drop.
Usage Guidelines
The ACL meter configured with this command will be associated with an ACL by specifying the meter
name in the action modifier field of the ACL entry. The
ACL, or the packet will be dropped regardless of the metering state.
The keyword specifies the traffic rate allowed for this meter. The committed traffic rate
committed-rate
may be specified in Kbps, Mbps, or Gbps. The
for GE ports and 1 Mbps to 10 Gbps for 10GE ports. The
maximum number of consecutive bits that are allowed to be in-profile at wire-speed. The
parameter may be specified in Kb, Mb, or Gb. The specified
nearest supported size. For GE ports, the burst sizes are rounded down to the nearest 32Kb, 64Kb,
128Kb, 256Kb, 512Kb, 1Mb, 2Mb, 4Mb, and additionally 8Mb, 16Mb, 32Mb, 64Mb, 128Mb, 256Mb,
512Mb, or 1Gb for 10 GE ports.
The keyword
out-actions
supported actions include dropping the packet, marking the drop precedence for the packet, or setting
the DSCP value in the packet. The keyword
dropped. The keyword
set-drop-precedence
If the optional keyword
set-dscp
, is written into the out-of-profile packet. Setting the DSCP value to
value
the packet unchanged.
ExtremeWare XOS 11.3 Command Reference
Specifies the ACL meter name.
Specifies the maximum burst size.
Specifies the committed rate.
Specifies actions to take if traffic exceeds the profile.
Specifies to drop out of profile traffic.
Specifies to mark packet for high drop precedence.
Specifies to set DSCP.
Specifies to leave the DSCP value unchanged.
committed-rate
specifies the action that is taken when a packet is out-of-profile. The
indicates that any out-of-profile packet is immediately
drop
marks out-of-profile packets with high drop precedence.
is specified, the DSCP value, as specified by the parameter
keyword should not be an action for the
deny
parameter range is 64Kbps to 1 Gbps
keyword specifies the
max-burst-size
will be rounded down to the
burst-size
leaves the DSCP value in
none
configure meter
burst-size
dscp-
667