Configure Eaps Add Control Vlan - Extreme Networks ExtremeWare XOS Command Reference Manual

configure eaps add control vlan

configure eaps <name> add control vlan <vlan_name>
Description
Adds the specified control VLAN to the specified EAPS domain.
Syntax Description
name
vlan_name
Default
N/A.
Usage Guidelines
You must configure one control VLAN for each EAPS domain. The control VLAN is used only to send
and receive EAPS messages.
The VLAN that will act as the control VLAN must be configured as follows:
The VLAN must NOT be assigned an IP address, to avoid loops in the network.
●
Only ring ports may be added as members of the control VLAN.
●
The ring ports of the control VLAN must be tagged.
●
NOTE
Extreme Networks recommends assigning the control VLAN a QoS profile of Qp8 with the QoS profile priority setting
of HighHi to ensure that EAPS control VLAN traffic is serviced prior to other traffic and reaches its intended
destination.
A control VLAN cannot belong to more than one EAPS domain. When the EAPS domain is active, you
cannot delete or modify the configuration of the control VLAN.
Example
The following command adds the control VLAN "keys" to the EAPS domain "eaps_1."
configure eaps eaps_1 add control vlan keys
History
This command was first available in ExtremeWare XOS 11.0.
ExtremeWare XOS 11.3 Command Reference
Specifies the name of an EAPS domain.
Specifies the name of the control VLAN.
configure eaps add control vlan
893