Configure Sys-Recovery-Level - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Status Monitoring and Statistics

configure sys-recovery-level

configure sys-recovery-level [all | none]
Description
Configures a recovery option for instances where an exception occurs in ExtremeWare XOS.
Syntax Description
all
none
Default
The default setting is
Usage Guidelines
Use this command for system troubleshooting. If the system fails, the switch will automatically reboot
or leave the system in its current state. You must specify one of the following parameters for the system
to respond to software failures:
—The system will reboot or shut down if any task exception occurs.
●
all
—No action is taken when a task exception occurs.
●
none
The system will always reboot after a task exception when the system recovery level is specified as all.
Extreme Networks recommends using the default setting.
Displaying the System Recovery Setting. To display the system recovery setting on the switch, use the
following command:
show switch
This command displays general switch information, including the system recovery level. The following
truncated output displays the system recovery setting (displayed as
SysName:
SysLocation:
SysContact:
System MAC:
Recovery Mode:
System Watchdog:
494
Configures ExtremeWare XOS to log an error into the syslog and either
shutdown or reboot the system after any task exception occurs.
Configures the level to no recovery. No action is taken when a task exception
occurs; there is no system shutdown or reboot.
.
all
TechPubs Lab
support@extremenetworks.com, +1 888 257 3000
00:04:96:1F:A4:0E
All
Enabled
):
Recovery Mode
ExtremeWare XOS 11.3 Command Reference