Extreme Networks ExtremeWare XOS Command Reference Manual page 442

Power Over Ethernet Commands
Curr—Displays the measured current, in milliamperes, drawn by the PD.
●
Power—Displays the measured power, in watts, supplied to the PD.
●
Fault—Displays the fault value:
●
None
■
UV/OV fault
■
UV/OV spike
■
Over current
■
Overload
■
Undefined
■
Underload
■
HW fault
■
Discovery resistance fail
■
Operator limit violation
■
Disconnect
■
Discovery resistance, A2D failure
■
Classify, A2D failure
■
Sample, A2D failure
■
Device fault, A2D failure
■
Force on error
■
The detail command lists all inline power information for the selected ports. Detail output displays the
following information:
Configured Admin State—Displays the port's configured state; Enabled or Disabled.
●
Inline Power State—Displays the port power state.
●
MIB Detect Status—Displays the port state as reported by SNMP; valid values are as follows:
●
disabled
■
searching
■
delivering
■
fault
■
test
■
otherFault
■
denyLowPriority
■
Label—Displays the port's configured label.
●
Operator Limit—Displays the port's configured operator limit value.
●
PD Class—Displays the class type of connected PD:
●
Max Allowed Power—Displays the amount of maximum allowed power for a device of this class.
●
Measured Power—Displays the measured power, in watts, supplied to the PD.
●
Line Voltage—Displays the measured voltage. A value from 0 to 2 is valid for ports in a searching
●
state.
Current—Displays the measured current, in milliamperes, drawn by the PD.
●
Fault Status—Displays the fault value.
●
442
ExtremeWare XOS 11.3 Command Reference