Extreme Networks ExtremeWare XOS Command Reference Manual page 255

rm
rm {memorycard} <file-name>
Description
Removes/deletes an existing configuration or policy file from the system.
Syntax Description
memorycard
file-name
Default
N/A.
Usage Guidelines
After you remove a configuration or policy file from the system, that file is unavailable to the system.
You cannot remove an active configuration file (the configuration currently selected to boot the switch).
To verify the configuration that you are currently using, issue the
you attempt to remove the active configuration file, the switch displays a message similar to the
following:
Error: Cannot remove current selected active configuration file.
When you delete a file from the switch, a message similar to the following appears:
Remove testpolicy.pol from switch? (y/n)
Enter to remove the file from your system. Enter
y
system.
Case-sensitive Filenames. Filenames are case-sensitive. In this example, you have a configuration file
named Test.cfg. If you attempt to remove a file with the incorrect case, for example test.cfg, the system
is unable to remove the file. The switch does not display an error message; however, the
continues to display the file Test.cfg. To remove the file, make sure you use the appropriate case.
Local Filename Character Restrictions. This section provides information about the characters supported
by the switch for local filenames.
When specifying a local filename, the switch permits only the following characters:
Alphabetical letters, upper case and lower case (A-Z, a-z)
●
Numerals (0-9)
●
Period ( . )
●
ExtremeWare XOS 11.3 Command Reference
Specifies the removable external compact flash card.
NOTE: This parameter is available only on modular switches.
Specifies the name of the configuration or policy file.
to cancel the process and keep the file on your
n
show switch {detail}
ls
rm
command. If
command
255