Unconfigure Vlan Ipaddress - Extreme Networks ExtremeWare XOS Command Reference Manual

VLAN Commands

unconfigure vlan ipaddress

unconfigure vlan <vlan_name> ipaddress {<ipv6_address_mask>}
Description
Removes the IP address of the VLAN or a VMAN. With no parameters, the command removes the
primary IPv4 address on the specified VLAN. Using the IPv6 parameters, you can remove specified
IPv6 addresses from the specified VLAN.
Syntax Description
vlan_name
ipv6_address_mask
Default
Removes the primary IPv4 address from the specified VLAN.
Usage Guidelines
If you do not specify any parameters, this command removes the primary IPv4 address from the VLAN.
NOTE
With IPv6, you cannot remove the last link local IPv6 address until all global IPv6 addresses are removed.
Beginning with ExtremeWare XOS software version 11.3, you can use this command to unconfigure the
IP address for a VMAN as well.
Example
The following command removes the primary IPv4 address from the VLAN accounting:
unconfigure vlan accounting ipaddress
The following command removes an IPv6 addresses from the VLAN finance:
unconfigure vlan finance ipaddress 3ffe::1
History
This command was first available in ExtremeWare XOS 10.1.
The IPv6 parameters were added in ExtremeWare XOS 11.2.
622
Specifies a VLAN name.
Specifies an IPv6 address using the format of IPv6-address/prefix-length, where
IPv6 is the 128-bit address and the prefix length specifies the number of
leftmost bits that comprise the prefix.
ExtremeWare XOS 11.3 Command Reference