Configure Eaps Fast-Convergence - Extreme Networks ExtremeWare XOS Command Reference Manual

EAPS Commands

configure eaps fast-convergence

configure eaps fast-convergence [off | on]
Description
Enables EAPS to converge more quickly.
Syntax Description
off
on
Default
Default is off.
Usage Guidelines
This command acts on the switch, not per domain.
In certain environments to keep packet loss to a minimum when the ring is broken, configure EAPS
with fast-convergence turned on. If fast convergence is turned on, it will be displayed under the
command. For example:
eaps
show eaps
EAPS Enabled: No
EAPS Fast-Convergence: Off
Number of EAPS instances: 0
# EAPS domain configuration :
--------------------------------------------------------------------------------
Domain
--------------------------------------------------------------------------------
NOTE
If fast-convergence is turned on, the link filters on all EAPS ring ports are turned off. This can result problems if the
port's hardware encountered a problem and started "flapping" between link-up/link-down states.
Example
The following command configures fast convergence for all of the EAPS domains on the switch:
configure eaps fast-convergence on
902
Turns fast-convergence off. Default is off.
Turns fast-convergence on.
State Mo En Pri Sec Control-Vlan VID
ExtremeWare XOS 11.3 Command Reference
show
Count