Show Lacp - Extreme Networks ExtremeWare XOS Command Reference Manual

show lacp

show lacp
Description
Displays LACP, or dynamic link aggregation, settings on the switch.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
This command displays the following information about the LACP LAGs configured on the switch:
Up or Down
●
Enabled or disabled (not configurable)
●
System MAC
●
MAC address for the system, which is used for LACP priority in the absence of a specifically
■
configured priority.
LACP PDUs dropped on non-LACP ports
●
LAG
●
Identifies the particular LAG. This number comes from logical port assigned to the LAG and is
■
the LAG group ID.
Actor Sys-Pri
●
Shows the system priority for that LAG.
■
If this number is lower than the number displayed for the Partner Sys-Pri, the system you are
■
working on is the controlling partner in the LAG.
Actor Key
●
Automatically generated LACP key.
■
Partner MAC
●
Identifies the MAC address for the system connecting to the LAG on the remote end.
■
Partner Sys-Pri
●
Shows the system priority for that LAG on the remote end.
■
If this number is lower than the number displayed for the Actor Sys-Pri, the system at the remote
■
end is the controlling partner in the LAG.
Partner Key
●
LACP key automatically generated by the system to which this aggregator is connected.
■
ExtremeWare XOS 11.3 Command Reference
show lacp
341