Extreme Networks ExtremeWare XOS Command Reference Manual page 476

Commands for Status Monitoring and Statistics
Example
In the following example, the switch generates the identical event from the component SNTP, using
three different formats.
Using the default format for the session target, an example log message might appear as:
05/29/2005 12:15:25.00 <Warn:SNTP.RslvSrvrFail> The SNTP server parameter value
(TheWrongServer.example.com) can not be resolved.
If you set the current session format using the following command:
configure log target session format timestamp seconds date mm-dd-yyyy event-name
component
The same example would appear as:
05/29/2005 12:16:36 <Warn:SNTP> The SNTP server parameter value
(TheWrongServer.example.com) can not be resolved.
To provide some detailed information to technical support, you set the current session format using the
following command:
configure log target session format timestamp hundredths date mmm-dd event-name
condition source-line process-name
The same example would appear as:
May 29 12:17:20.11 SNTP: <Warn:SNTP.RslvSrvrFail> tSntpc: (sntpcLib.c:606) The SNTP
server parameter value (TheWrongServer.example.com) can not be resolved.
History
This command was first available in ExtremeWare XOS 10.1.
The and parameters were first introduced in ExtremeWare XOS 11.1.
ipPort host-name
Platform Availability
This command is available on all platforms.
476
ExtremeWare XOS 11.3 Command Reference