Configure Ports Qosprofile - Extreme Networks ExtremeWare XOS Command Reference Manual

configure ports qosprofile

configure ports <port_list> {qosprofile} <qosprofile>
Description
Configures one or more ports to use a particular egress QoS profile.
Syntax Description
port_list
qosprofile
Default
All ports have the default qosprofile of QP1.
Usage Guidelines
Extreme switches support eight QoS profiles (QP1 to QP8) for each port.
NOTE
This command applies only to untagged packets.
BlackDiamond 8800 family of switches (formerly known as Aspen) and Summit X450 switch only. You must
use this command to assign a QoS profile to ports. This command applies to egress QoS profiles only;
the BlackDiamond 8800 family of switches and the Summit X450 switch support only egress QoS
profiles.
BlackDiamond 10K switch. This command refers to egress QoS profiles; it assigns traffic ingressing this
port to a specified egress QoS profile. Use the
assign the ingress QoS profiles to ports; the ingress QoS profiles assign ingressing traffic to a specified
queue to the backplane.
Example
The following command configures port 5 on slot 5 on a modular switch to use QoS profile QP3:
configure ports 5:5 qosprofile QP3
History
This command was first available in ExtremeWare XOS 11.0.
ExtremeWare XOS 11.3 Command Reference
Specifies a list of ports or slots and ports.
Specifies a QoS profile.
configure qosprofile ingress ports
configure ports qosprofile
command to
695