Clear Counters Stp - Extreme Networks ExtremeWare XOS Command Reference Manual

STP Commands

clear counters stp

clear counters stp {[all | diagnostics | domains | ports]}
Description
Clears, resets all STP statistics and counters.
Syntax Description
all
diagnostics
domains
ports
Default
N/A.
Usage Guidelines
If you do not enter a parameter, the result is the same as specifying the
all domains, ports, and diagnostics are reset.
Enter one of the following parameters to reset the STP counters on the switch:
—Specifies the counters for all STPDs and ports, and clears all STP counters
●
all
●
diagnostics
—Clears the domain level counters
●
domains
—Clears the counters for all ports and leaves the domain level counters
●
ports
Viewing and maintaining statistics on a regular basis allows you to see how well your network is
performing. If you keep simple daily records, you will see trends emerging and notice problems arising
before they cause major network faults. By clearing the counters, you can see fresh statistics for the time
period that you are monitoring.
Example
The following command clears all of the STP domain, port, and diagnostic counters:
clear counters stp
History
This command was available in ExtremeWare XOS 10.1.
938
Specifies all STP domain, port, and diagnostics counters.
Specifies STP diagnostics counters.
Specifies STP domain counters.
Specifies STP port counters.
—Clears the internal diagnostic counters
parameter: the counters for
all
ExtremeWare XOS 11.3 Command Reference