Extreme Networks ExtremeWare XOS Command Reference Manual page 332

Commands for Configuring Slots and Ports on a Switch
On the BlackDiamond 10K switch, if you do not explicitly select an algorithm, the port-based scheme is
used. However, the address-based algorithm has a more even distribution and is the recommended
choice.
NOTE
You must use the command to configure address-based load sharing on
configure sharing address-based
the BlackDiamond 10K switch.
Example
The following example defines a static link aggregation group (LAG) on a modular switch that contains
ports 9 through 12 on slot 3, ports 7 through 10 on slot 5, and uses the first port on slot 3 as the logical
port 9 on a modular switch:
enable sharing 3:9 grouping 3:9-3:12, 5:7-5:10
In this example, logical port 3:9 represents physical ports 3:9 through 3:12 and 5:7 through 5:10.
The following example defines a dynamic LAG on a stand-alone switch containing ports 10 through 15,
with port 10 being the logical port:
enable sharing 10 grouping 10-15 lacp
History
This command was first available in ExtremeWare XOS 10.1.
The address-based algorithm was added in ExtremeWare XOS 11.0.
The L2 and L3 optional parameters were added in ExtremeWare XOS 11.1.
IPv6-compatibility was added in ExtremeWare XOS 11.2.
Dynamic link aggregation, using LACP, was added in ExtremeWare XOS 11.3.
Platform Availability
This command is available on all platforms.
332
ExtremeWare XOS 11.3 Command Reference