Create Qosprofile - Extreme Networks ExtremeWare XOS Command Reference Manual

create qosprofile

create qosprofile
create qosprofile [QP2| QP3 | QP4 | QP5 | QP6 | QP7]
Description
Creates a QoS profile.
Syntax Description
QP1....QP7 Specifies the QoS profile you want to create.
Default
N/A.
Usage Guidelines
The BlackDiamond 8800 family of switches (formerly known as Aspen) and the Summit X450 switch
allow dynamic creation and deletion of QoS queues, with Q1 and Q8 always available, rather than the 8
fixed queues on the BlackDiamond 10K switch.
You must create the QoS profile before you can configure it. or assign it to ports or VLANs. Use the
command to
configure qosprofile <qosprofile> {maxbuffer <percent>} {weight <value>}
configure the QoS profile once you create it. Use the
configure ports <port_list> {qosprofile}
command to associate a QoS profile with ports and the
<qosprofile> configure vlan <vlan_name>
command to associate a QoS profile with VLANs.
{qosprofile} <qosprofile>
QoS profiles QP1 and QP8 are defaults and cannot be deleted.
NOTE
The sFlow application uses QP2 to sample traffic on the BlackDiamond 8800 family of switches and the Summit
X450 switch. Any traffic grouping using QP2 may encounter unexpected results when sFlow is enabled.
Example
The following command creates the user-created QoS profile QP3:
create qosprofile qp3
History
This command was first available in ExtremeWare XOS 11.1.
707
ExtremeWare XOS 11.3 Command Reference