Commands for Status Monitoring and Statistics
unconfigure log target format
unconfigure log target [console | memory-buffer | nvram | session | syslog
[all | <ipaddress> | <ipPort> {vr <vr_name>} [local0 ... local7]]] format
Description
Resets the log target format to its default values.
Syntax Description
console
memory-buffer
nvram
session
syslog
all
ipaddress
ipPort
vr_name
local0 ... local7
format
Default
When a target format is unconfigured, it is reset to the default values.
The following defaults apply to console display, memory buffer, NVRAM, and session targets:
timestamp—hundredths
●
date—mm-dd-yyyy
●
severity—on
●
event-name—condition
●
host-name—off
●
sequence-number—off
●
process-name—off
●
process-slot—on (modular switches only)
●
process-id—off
●
source-line—off
●
The following defaults apply to syslog targets (per RFC 3164):
timestamp—seconds
●
date—mmm-dd
●
574
Specifies the console display format.
Specifies the switch memory buffer format.
Specifies the switch NVRAM format.
Specifies the current session (including console display) format.
Specifies a syslog target format.
Specifies all remote syslog servers.
Specifies the syslog IP address.
Specifies the UDP port number for the syslog target.
Specifies the virtual router that can reach the server IP address.
NOTE: The BlackDiamond 8800 family of switches and the Summit X450
switch do not support user-created VRs.
Specifies the local syslog facility.
Specifies that the format for the target will be reset to the default value.
ExtremeWare XOS 11.3 Command Reference