Configure Ports Auto-Polarity - Extreme Networks ExtremeWare XOS Command Reference Manual

configure ports auto-polarity

configure ports [<port_list> | all] auto-polarity [off | on]
Description
Configures the autopolarity detection feature on the specified Ethernet ports.
Syntax Description
port_list
all
off
on
Default
Enabled.
Usage Guidelines
This feature applies to only the 10/100/1000 BASE-T ports on the switch.
Use the keyword to enable or disable the autopolarity detection feature on all of the Ethernet ports
all
on the Summit X450 switch and the BlackDiamond 8800 family of switches (formerly known as Aspen).
When autopolarity is disabled on one or more Ethernet ports, you can verify that status by using the
command:
show ports information detail
Example
The following command disables the autopolarity detection feature on ports 5 to 7 on the Summit X450
switch:
configure ports 5-7 auto-polarity off
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available only on the Summit X450 switch and the BlackDiamond 8800 family of
switches.
ExtremeWare XOS 11.3 Command Reference
Specifies one or more ports on the switch.
Specifies all of the ports on the switch.
Disables the autopolarity detection feature on the specified ports.
Enables the autopolarity detection feature on the specified ports.
configure ports auto-polarity
297