Show Vlan - Extreme Networks ExtremeWare XOS Command Reference Manual

VLAN Commands

show vlan

show vlan {detail |<vlan_name> {stpd}}
Description
Displays information about VLANs.
Syntax Description
detail
vlan_name
stpd
Default
Summary information for all VLANs on the device.
Usage Guidelines
NOTE
To display IPv6 information, you must issue either the show vlan detail command or show vlan command
with the name of the specified VLAN.
Unlike many other VLAN-related commands, the keyword "vlan" is required in all forms of this
command except when requesting information for a specific vlan.
Use the command
configuration options as a series of "flags" (see the example below). VLAN and protocol names may be
abbreviated in this display.
Use the command
same information as for an individual VLAN, but shows every VLAN, one-by-one. After each VLAN
display you can elect to continue or quit.
Protocol
none
subsequently been deleted.
NOTE
The BlackDiamond 8800 family of switches and the Summit X450 switch display the Mgmt VLAN in the VR-Mgmt;
they display all other VLANs in the VR-Default.
616
Specifies that detailed information should be displayed for each VLAN.
Specifies a VLAN name.
Specifies that STP domains displays for each VLAN.
to display summary information for all VLANs. It shows various
show vlan
show vlan detail
indicates that this VLAN was configured with a user-defined protocol that has
to display detailed information for all VLANs. This displays the
ExtremeWare XOS 11.3 Command Reference