Configure Inline-Power Priority Ports - Extreme Networks ExtremeWare XOS Command Reference Manual

configure inline-power priority ports

configure inline-power priority [critical | high | low] ports <port_list>
Description
Sets the PoE priority on the specified ports.
Syntax Description
critical | high | low
port_list
Default
Low.
Usage Guidelines
The system allocates power to those ports with the highest priorities first. This command can also be
used in conjunction with the
configure the disconnect precedence as lowest priority, then newly detected PDs will be powered if that
port has higher priority than the existing powered ports.
If there are multiple ports at the same priority level (either configured, or by default) and one of the
ports must have power withdrawn because of excessive power demands, those ports with the lower
port number are powered first. The higher port numbers have power withdrawn first in the case of
equal PoE port priorities.
Example
The following command assigns a critical PoE priority on ports 4 – 6 on slot 3:
configure inline-power priority critical ports 3:4-3:6
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available only on the G48P module installed in the BlackDiamond 8800 family of
switches.
ExtremeWare XOS 11.3 Command Reference
Sets the PoE priority for the specified ports.
Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.
configure inline-power disconnect-precedence
configure inline-power priority ports
command. If you
421