Tftp - Extreme Networks ExtremeWare XOS Command Reference Manual

tftp

tftp [<host_name> | <ip_address>] {-v <vr_name>} [-g | -p] [{-l
[<local_file> | memorycard <local-file-memcard>]} {-r <remote_file>} | {-r
<remote_file>} {-l [<local_file> | memorycard <local-file-memcard]}]
Description
Allows you to TFTP from the current command line interface session to a TFTP server.
Syntax Description
host_name
ip_address
vr_name
-g
-p
local_file
memorycard
remote_file
Default
If you do not specify a virtual router, VR-Mgmt is used.
Usage Guidelines
NOTE
The BlackDiamond 8800 family of switches and the Summit X450 switch do not support user-created VRs.
NetASCII and mail file type formats are not supported.
TFTP Server Requirements. Extreme Networks recommends using a TFTP server that supports blocksize
negotiation (as described in RFC 2348, TFTP Blocksize Option), to enable faster file downloads and larger
file downloads. If the TFTP server does not support blocksize negotiation, the file size is limited to
32 MB. Older TFTP servers that do not support blocksize negotiation have additional implementation
limits that may decrease the maximum file size to only 16 MB, which may be too small to install
ExtremeWare XOS images.
ExtremeWare XOS 11.3 Command Reference
Specifies the name of the remote host.
Specifies the IP address of the TFTP server.
Specifies the name of the virtual router.
NOTE: The BlackDiamond 8800 family of switches and the Summit X450
switch do not support user-created VRs.
Gets the specified file from the TFTP server and copies it to the local host.
Puts the specified file from the local host and copies it to the TFTP server.
Specifies the name of the file (configuration file, policy file) on the local host.
Specifies the removable external compact flash card.
NOTE: This parameter is available only on modular switches.
Specifies the name of the file on the remote host.
tftp
233