Extreme Networks ExtremeWare XOS Command Reference Manual page 465

configure log filter events
More Information. See the command on page 532 for more information about severity levels.
show log
To get a listing of the components present in the system, use the following command:
show log components
To get a listing of event condition definitions, use the following command:
show log events
To see the current configuration of a filter, use the following command:
show log configuration filter {<filter name>}
Example
The following command adds all STP component events at severity to the filter mySTPFilter:
info
configure log filter myStpFilter add events stp severity info
The following command adds the STP.OutBPDU subcomponent, at the pre-defined severity level for
that component, to the filter myStpFilter:
configure log filter myStpFilter add events stp.outbpdu
The following command excludes one particular event, STP.InBPDU.Drop, from the filter:
configure log filter myStpFilter add exclude events stp.inbpdu.drop
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
465
ExtremeWare XOS 11.3 Command Reference