Configure Sflow Collector Ipaddress - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Status Monitoring and Statistics

configure sflow collector ipaddress

configure sflow collector {ipaddress} <ip-address> {port <udp-port-number>}
{vr <vrname>}
Description
Configures the sFlow collector IP address.
Syntax Description
ip-address
udp-port-number
vrname
Default
The following values are the defaults for this command:
UDP port number—6343
●
Virtual router—VR-Mgmt (previously called VR-0).
●
Usage Guidelines
NOTE
The BlackDiamond 8800 family of switches and the Summit X450 switch do not support user-created VRs.
This command allows you to configure where to send the sFlow data. You must specify an IP address
for the sFlow data collector, and you may specify a particular UDP port, if your collector uses a non-
standard port. You may also need to specify from which virtual router to send the data.
You can configure up to four sFlow collectors. Each unique IP address/UDP port/virtual router
combination identifies a collector.
Both the commands
parameters to the default.
Example
The following command specifies that sFlow data should be sent to port 6343 at IP address 192.168.57.1
using the virtual router VR-Mgmt:
configure sflow collector ipaddress 192.168.57.1
484
Specifies the IP address to send the sFlow data.
Specifies the UDP port to send the sFlow data.
Specifies from which virtual router to send the sFlow data.
NOTE: The BlackDiamond 8800 family of switches and the Summit X450
switch do not support user-created VRs.
and
unconfigure sflow unconfigure sflow collector
ExtremeWare XOS 11.3 Command Reference
will reset the collector