9
VLAN Commands
This chapter describes commands for:
Creating and deleting VLANs and performing basic VLAN configuration
●
Defining protocol filters for use with VLANs
●
Creating and deleting VMANs and performing basic VMAN configuration
●
VLANs can be created according to the following criteria:
Physical port—A port-based VLAN consists of a group of one or more ports on the switch. A port
●
can be a member of only one port-based VLAN, and is by default a member of the VLAN named
Default.
802.1Q tag—Tagging is most commonly used to create VLANs that span switches.
●
Ethernet, LLC SAP, or LLC/SNAP Ethernet protocol type—Protocol-based VLANs are most often
●
used in situations where network segments contain hosts running multiple protocols.
A combination of these criteria.
●
Beginning with ExtremeWare XOS 11.2, the software supports using IPv6 addresses, in addition to IPv4
addresses.
ExtremeWare XOS 11.3 Command Reference
585