Traceroute - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Accessing the Switch

traceroute

traceroute {vr <vrid>} {ipv4 <host>} {ipv6 <host>} {ttl <number>} {from
<from>} {[port <port>] | icmp}
Description
Enables you to trace the routed path between the switch and a destination endstation.
Syntax Description
vr
vrid
ipv4
ipv6
host
ttl <number>
from <from>
port <port>
icmp
Default
N/A.
Usage Guidelines
NOTE
The BlackDiamond 8800 family of switches and the Summit X450 switch do not support user-created virtual
routers.
Each router along the path is displayed.
Beginning with ExtremeWare XOS 11.2, you can trace the routed path between the switch and the given
IPv6 address.
100
Specifies a virtual router.
NOTE: User-created VRs are not available on the BlackDiamond 8800 family
of switches or the Summit X450 switch.
Specifies which virtual router.
NOTE: User-created VRs are not available on the BlackDiamond 8800 family
of switches or the Summit X450 switch
Specifies IPv4 transport.
Specifies IPv6 transport.
Specifies the host of the destination endstation.
Configures the switch to trace up to the time-to-live number of the switch.
Uses the specified source address in the ICMP packet. If not specified, the
address of the transmitting interface is used.
Specifies the UDP port number.
Configures the switch to send ICMP echo messages to trace the routed path
between the switch and a destination endstation.
ExtremeWare XOS 11.3 Command Reference