Configure Vlan Dhcp-Address-Range - Extreme Networks ExtremeWare XOS Command Reference Manual

configure vlan dhcp-address-range

configure vlan <vlan_name> dhcp-address-range <ipaddress1> - <ipaddress2>
Description
Configures a set of DHCP addresses for a VLAN.
Syntax Description
vlan_name
ipaddress1
ipaddress2
Default
N/A.
Usage Guidelines
The following error conditions are checked: ipaddress2 >= ipaddress1, the range must be in the VLAN's
network, the range does not contain the VLAN's IP address, and the VLAN has an IP address assigned.
Example
The following command allocates the IP addresses between 192.168.0.20 and 192.168.0.100 for use by the
VLAN temporary:
configure temporary dhcp-address-range 192.168.0.20 - 192.168.0.100
History
This command was first available in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.
ExtremeWare XOS 11.3 Command Reference
Specifies the VLAN on whose ports DHCP will be enabled.
Specifies the first IP address in the DHCP address range to be assigned to this
VLAN.
Specifies the last IP address in the DHCP address range to be assigned to this
VLAN.
configure vlan dhcp-address-range
769