Extreme Networks ExtremeWare XOS Command Reference Manual page 305

NOTE
You cannot configure port-based load sharing algorithm on the BlackDiamond 8800 family of switches and the
Summit X450 switch; you configure only address-based load-sharing algorithms.
The available address-based parameters on the BlackDiamond 8800 family of switches and the Summit
X450 switch are L2 for Layer 2 and L3 for Layer 3. If the packet is not IP, the switch applies the Layer 2
algorithm, which is the default setting.
BlackDiamond 10K switch only. The following guidelines apply to LAGs on the BlackDiamond 10K
switch:
A static LAG can include a maximum 16 ports.
●
An LACP (dynamic) LAG can include a maximum of 32 ports; out of these up to 16 can be selected
●
links and the remaining 16 will be standby links.
The maximum number of LAGs is 128.
●
On the BlackDiamond 10K switch, if you do not explicitly select an algorithm, the port-based scheme is
used. However, the address-based algorithm has a more even distribution and is the recommended
choice.
NOTE
You must use the
configure sharing address-based
the BlackDiamond 10K switch.
Example
The following example adds port 3:13 to the LAG with the logical port 3:9 on a modular switch:
configure sharing 3:9 add port 3:13
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
ExtremeWare XOS 11.3 Command Reference
configure sharing add ports
command to configure address-based load sharing on
305