Configure Diffserv Replacement - Extreme Networks ExtremeWare XOS Command Reference Manual

configure diffserv replacement

configure diffserv replacement [{qosprofile} <qosprofile> | priority
<value>] code-point <code_point>
Description
Configures the default egress DiffServ replacement mapping.
Syntax Description
qosprofile
value
code_point
Default
N/A.
Usage Guidelines
NOTE
Extreme Networks recommends that you use the qosprofile <qosprofile> value to configure this parameter.
The default QoS profile to 802.1p priority value to code point mapping is shown in
Table 20: Default QoS profile-to-802.1p priority value-to-code point
BlackDiamond 10K switch
802.1p priority value QoS profile
0 QP1
1 QP2
2 QP3
3 QP4
4 QP5
5 QP6
6 QP7
7 QP8
ExtremeWare XOS 11.3 Command Reference
Specifies a QoS profile.
Specifies the 802.1p priority value.
Specifies a 6-bit value to be used as the replacement code point in the
DiffServ (IP-TOS byte) of the IP header.
BlackDiamond 8800 family of switches
and the Summit X450 switch
QoS profile
QP1
QP1
QP1
QP1
QP1
QP1
QP1
QP8
configure diffserv replacement
Table 20.
Code point
0
8
16
24
32
40
48
56
691