Configure Radius Server - Extreme Networks ExtremeWare XOS Command Reference Manual

Security Commands

configure radius server

configure radius {mgmt-access | netlogin} [primary | secondary] server
[<ipaddress> | <hostname>] {<udp_port>} client-ip [<ipaddress>] {vr
<vr_name>}
Description
Configures the primary and secondary RADIUS authentication server.
Syntax Description
mgmt-access
netlogin
primary
secondary
ipaddress
hostname
udp_port
ipaddress
vr_name
Default
The following lists the default behavior of this command:
The UDP port setting is 1812
●
The virtual router used is VR-Mgmt, the management virtual router
●
Switch management and network login use the same primary and secondary RADIUS servers for
●
authentication.
Usage Guidelines
NOTE
The BlackDiamond 8800 family of switches and the Summit X450 switch do not support user-created VRs.
Use this command to specify RADIUS server information.
Use of the
<hostname>
The RADIUS server defined by this command is used for user name authentication and CLI command
authentication.
742
Specifies the RADIUS authentication server for switch management.
Specifies the RADIUS authentication server for network login.
Configures the primary RADIUS authentication server.
Configures the secondary RADIUS authentication server.
The IP address of the server being configured.
The host name of the server being configured.
The UDP port to use to contact the RADIUS authentication server.
The IP address used by the switch to identify itself when communicating with
the RADIUS authentication server.
Specifies the virtual router on which the client IP is located.
NOTE: The BlackDiamond 8800 family of switches (formerly known as Aspen)
and the Summit X450 switch do not support user-created VRs.
parameter requires that DNS be enabled.
ExtremeWare XOS 11.3 Command Reference