Extreme Networks ExtremeWare XOS Command Reference Manual page 480

Commands for Status Monitoring and Statistics
Usage Guidelines
NOTE
The BlackDiamond 8800 family of switches and the Summit X450 switch do not support user-created VRs.
This command configures the specified target with a severity level. The filter associated with the target
is not affected. A message is sent to a target if the target has been enabled, the message passes the
associated filter, the message is at least as severe as the configured severity level, and the message
output matches the regular expression specified.
See the command
To see the current configuration of a target, use the following command:
show log configuration target {console | memory-buffer | nvram | primary-msm | backup-
msm | session | syslog {<ipaddress> | <ipPort> | vr <vr_name>} [local0 ... local7]}
To see the current configuration of a filter, use the following command:
show log configuration filter {<filter name>}
Example
The following command sends log messages to the current session, that pass the current filter at a
severity level of info or greater, and contain the string user5:
configure log target session severity info
History
This command was first available in ExtremeWare XOS 10.1.
The
primary-msm
The parameter was first available in ExtremeWare XOS 11.1.
ipPort
Platform Availability
This command is available on all platforms.
480
on page 532 for a detailed description of severity levels.
show log
and options were first available in ExtremeWare XOS 11.0.
backup-msm
ExtremeWare XOS 11.3 Command Reference