Extreme Networks ExtremeWare XOS Command Reference Manual page 617

When an IPv6 address is configured for the VLAN, the system may display one of the following two
address types in parentheses after the IPv6 address:
Tentative
●
Duplicate
●
NOTE
See the ExtremeWare XOS Concepts Guide for information on IPv6 address types.
You can display additional useful information on VLANs configured with IPv6 addresses by issuing the
show ipconfig ipv6 vlan <vlan_name>
BD10K # show ipconfig ipv6 my_ipv6_100
Router Interface on my_ipv6_100 is enabled and up. MTU: 1500
Locally registered unicast addresses:
2001:db8::8:802:200c:417a/64
fe80::230:48ff:fe41:ed97%my_ipv6_100/64
Flags:
IPv6 Forwarding: YES Accept recvd RA: NO
Send redirects: NO Accept redirects: NO
Example
The following is an example of the
--------------------------------------------------------------------------------
Name VID Protocol Addr
--------------------------------------------------------------------------------
Default 1
hugheapscontrol 4092 --------------------
Mgmt 4095 --------------------
peggy 4094 10.0.0.1
santaclara 4091 --------------------
--------------------------------------------------------------------------------
Flags : (C) EAPS Control vlan, (E) ESRP Enabled, (f) IP Forwarding Enabled,
(i) ISIS Enabled, (I) IP Forwarding lpm-routing Enabled, (L) Loopback
Enabled, (m) IPmc Forwarding Enabled,
(n) IP Multinetting Enabled, (N) Network LogIn vlan,
(o) OSPF Enabled, (p) PIM Enabled,
(P) EAPS protected vlan, (r) RIP Enabled, (T) Member of STP Domain,
(v) VRRP Enabled, (d) Dynamically created VLAN
Total number of Vlan(s) : 5
The following is an example of the
VLAN Interface with name Default created by user
Tagging:
Priority:
Virtual router: VR-Default
Primary IP:
ExtremeWare XOS 11.3 Command Reference
. The following is sample output from this command:
command on the BlackDiamond 10K switch:
show vlan
--------------------
/8
show vlan Default
802.1Q Tag 1
802.1P Priority 0
10.0.0.1/8
Flags Proto
Active router
/Total
---------T--- ANY
------------C ANY
------------- ANY
-L----------- ANY
------------d ANY 0 /1
command:
show vlan
Ports Virtual
0 /771 VR-Default
0 /0 VR-Default
1 /1 VR-Mgmt
1 /2 VR-Default
benton
617