Baseline Bridge Interface Vpls - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

baseline bridge interface vpls

Syntax
Release Information
Description
Options
Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
baseline bridge interface vpls vplsName
Command introduced in JunosE Release 7.1.0.
Sets a statistics baseline for a VPLS instance on the VPLS virtual core interface, which
represents all of the MPLS tunnels from the router to the remote VPLS edge (VE) devices.
The router implements the baseline by reading and storing the statistics at the time the
baseline is set and then subtracting this baseline whenever baseline-relative statistics
are retrieved. There is no no version.
NOTE: Using the baseline bridge interface vpls command affects the VPLS virtual core
interface, but has no effect on the network interfaces associated with the VPLS instance.
To set a statistics baseline for a VPLS network interface, use the baseline bridge interface
command.
vplsName—Name of a VPLS instance created with the bridge vpls
transport-virtual-router command
Privileged Exec
Setting a Baseline for VPLS Statistics in the JunosE BGP and MPLS Configuration Guide
Chapter 3: B Commands
219