Fefd-Global - Dell Z9500 Command Reference Manual

Parameters
seconds
Defaults 15 seconds
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
Related
•
Commands
•

fefd-global

Enable FEFD globally on the system.
Z9500
Syntax
fefd-global [interval seconds][mode {normal | aggressive}]
To disable FEFD globally, use the no fefd-global [mode {normal |
aggressive}] command.
Parameters
interval
seconds
normal
aggressive
1170
Enter a number as the time between FEFD control packets.
The range is from 3 to 300 seconds. The default is 15
seconds.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
fefd — enables far-end failure detection.
fefd-global — enables FEFD globally on the system.
Enter the keyword interval followed by the number of
seconds to wait between FEFD control packets. Range is
from 3 to 300 seconds. Default is 15 seconds.
(OPTIONAL) Enter the keywords mode normal to change
the link state to "unknown" when a far-end failure the
software detects on that interface. When the interface is
placed in "unknown" state, the software brings down the line
protocol. The default is Normal mode.
(OPTIONAL) Enter the keywords mode aggressive to
change the link state to "error-disabled" when a far-end
failure the software detects on that interface. When an
Layer 2