NEC Univerge sv8500 Manual page 1783

(56) update
Setting of update method
This command is used to enable/disable the use of update method.
[Setting Example]
MG(SIP) > set update
Select the setting of UPDATE method.
0=disable(default)
1=enable
Input:0
Note: Assign this command adjusting to the specifications on the SIP network where MG-SIP128 [MG-
128SIPMGJ] connects.
(57) country_code
Setting of a country code
This command is used to set a country code on MG-SIP128 [MG-128SIPMGJ].
[Setting Example]
MG(SIP) > set country_code
0: Update method is disabled (Default)
1: Update method is enabled
VOL.2-1530
MG-SIP128 [MG-128SIPMGJ]