NEC Univerge sv8500 Manual page 1761

Select command(0:Exit/1:Set/2:Delete):2
No|Gateway Address|Destination network/
Prefix
--+---------------+------------------------
1 |192.168.0.254 |172.16.0.0
2 |192.168.0.254 |10.0.0.0
Select delete No?: 1
No|Gateway Address|Destination network/
Prefix
--+---------------+------------------------
1 |192.168.0.254 |10.0.0.0
Are you sure? Y/N=y
MG(SIP)>
Note:
The conditions of this command are as follows.
• To set a default gateway, it should be assigned to either one of the LAN side port or SIP network side port.
• Routing assignment is unnecessary for network segment assigned to Ether (0).
0: Exit (Exit the command without execut-
1: Set routing information.
2: Delete routing information.
Select "2".
Note: When there is no information to
/16
/8
Select the number (No) of the route infor-
mation you want to delete.
Select "1.
/8
Note: Pressing any key other than "y"
VOL.2-1508
MG-SIP128 [MG-128SIPMGJ]
ing anything.)
delete here, the following mes-
sage is displayed.
There is no static route table to delete.
displays the following message.
Route setting command was interrupted.