Configuring The Distance Of A Route; Changing The Is-Type - Dell S4048–ON Configuration Manual

S-series 10gbe switches
Hide thumbs Also See for S4048–ON:
Table of Contents

Advertisement

– default-metric: the range is from 0 to 63 if the metric-style is narrow, narrow-transition, or transition.
The range is from 0 to 16777215 if the metric style is wide or wide transition.
Assign a metric for an IPv6 link or interface.
INTERFACE mode
isis ipv6 metric default-metric [level-1 | level-2]
– default-metric: the range is from 0 to 63 for narrow and transition metric styles. The range is from 0 to 16777215 for
wide metric styles.
The default is 10.
The default level is level-1.
For more information about this command, refer to
The following table describes the correct value range for the isis metric command.
Metric Sytle
Correct Value Range
wide
0 to 16777215
narrow
0 to 63
wide transition
0 to 16777215
narrow transition
0 to 63
transition
0 to 63
To view the interface's current metric, use the show config command in INTERFACE mode or the show isis interface
command in EXEC Privilege mode.

Configuring the Distance of a Route

To configure the distance for a route, use the following command.
Configure the distance for a route.
ROUTER ISIS mode
distance

Changing the IS-Type

To change the IS-type, use the following commands.
You can configure the system to act as a Level 1 router, a Level 1-2 router, or a Level 2 router.
To change the IS-type for the router, use the following commands.
Configure IS-IS operating level for a router.
ROUTER ISIS mode
is-type {level-1 | level-1-2 | level-2-only}
Default is level-1-2.
Change the IS-type for the IS-IS process.
ROUTER ISIS mode
is-type {level-1 | level-1-2 | level-2}
Configuring the IS-IS Metric
Style.
Intermediate System to Intermediate System
457

Advertisement

Table of Contents
loading

Table of Contents