Configure Sys-Recovery-Level - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Status Monitoring and Statistics

configure sys-recovery-level

configure sys-recovery-level [all | none]
Description
Configures a recovery option for instances where an exception occurs in ExtremeWare XOS.
Syntax Description
all
none
Default
All.
Usage Guidelines
This command is used for system troubleshooting. If the system fails, the switch will automatically
reboot or leave the system in its current state. You must specify one of the following parameters for the
system to respond to software failures:
• —The system will reboot or shut down if any task exception occurs.
all
• —No action is taken when a task exception occurs.
none
The system will always reboot after a task exception when the system recovery level is specified as
Example
The following command configures a switch to not take an action when any task exception occurs:
configure sys-recovery-level none
History
This command was first available in ExtremeWare XOS 11.0.
338
Configures ExtremeWare XOS to log an error into the syslog and either
shutdown or reboot the system after any task exception occurs.
Configures the level to no recovery. No action is taken when a task exception
occurs; there is no system shutdown or reboot.
.
all
ExtremeWare XOS 11.0 Command Reference Guide