Table of Contents
Advertisement
11D-130 HCSS to Machine Communications Interface RAP
All communications between the machine and HCSS are conducted through a single interface
cable.
Procedure
Go to the 03-360, 03-408 to 03-410, 03-418 IOT to Output Device Error RAP.
WorkCentre 5687 Family
11E-130 Copy Damage in the HCSS RAP
Use this RAP to identify and correct the causes of copy damage in the HCSS.
Procedure
Switch off the electricity to the machine, GP 14. Disconnect the power cord. Electricity
can cause death or injury. Moving parts can cause injury.
Check the following:
•
Check the alignment between the machine and the HCSS, refer to ADJ 11.1-130.
•
Look for paper fragments in the HCSS paper path. Paper fragments can pass through the
IOT and HCSS paper path and wedge themselves at some point. A likely place for a piece
of paper to be wedged is at the hole punch assembly, where the top and bottom guides
form the narrowest part of the paper path.
•
Ensure that the diverter gate, PL 11.36 Item 1, operates correctly and has it's full move-
ment.
•
Ensure that the hole punches park at the fully open position. If they protrude even slightly,
a jam will occur in the narrow paper path of the hole punch. Refer to the 11-350-130 Hole
Punch Not Home RAP.
•
Check that all the idler rolls in the HCSS paper path are free to rotate, particularly those
on the jam clearance guides. Refer to ADJ 4.1 Machine Lubrication.
•
Make sure that the jam clearance guides 5a, 5b and 5d close and latch correctly.
•
Check that the paper path ribs of the jam clearance guide 5b, PL 11.36 Item 14 and the
lower exit cover, PL 11.32 Item 14, are free of scores and nicks. Check also for contami-
nation and glue from label stock.
•
Make sure that the vertical transport belts are located correctly, PL 11.42 Item 4.
•
Make sure that the compiler carriage tampers move to the correct paper size, refer to the
following:
–
11-005-130, 11-006-130, 11-310-130, 11-311-130 Front Tamper Move Failure RAP.
–
11-007-130, 11-008-130, 11-312-130, 11-313-130 Rear Tamper Move Failure RAP.
•
Check that the mylar guide on the vertical paper transport is located correctly and not
damaged, PL 11.40 Item 16.
•
Check that the paper size reported on the user interface corresponds to the actual paper
size loaded in the trays, refer to the 07D Tray 1 and 2 Wrong Size Paper RAP.
•
If heavy-weight paper is used, the paper can stop in the vertical transport and cause a 10-
126 fault. The fault is caused when the vertical transport motor is over loaded. Check the
position of the jam clearance guide 5a6a and 5B. Check the vertical transport rolls and
bearings for contamination. If necessary remove and clean the drive shaft and the bear-
ings. If the problem continues then install a new transport motor, PL 11.38 Item 5.
August 2007
2-441
WARNING
Status Indicator RAPs
11D-130, 11E-130
Hide quick links:
Advertisement
Chapters
Table of Contents
