Bin 1 Offset Failure Rap - Xerox WorkCentre 5687 Series Service Manual

11-031-170, 11-337-170 Bin 1 Offset Failure RAP

11-031-170 Bin 1 fails to offset.
11-337-170 Bin 1 is not at the offset home position.
NOTE: The offset home position is with bin 1 fully to the rear.
Initial Actions
Check that there is no damage or obstruction that would prevent bin 1 from moving. If neces-
sary, install a new bin 1, PL 11.78 Item 4.
Procedure
NOTE: All HCSS BM interlocks must be made to supply +24V to the motors.
Enter dC330, code 11-034 Bin 1 offset motor run, Figure 1. Bin 1 moves.
Y N
Go to Flag 2. Check the bin 1 offset motor, MOT11-034.
Refer to:
• GP 10, How to Check a Motor.
• P/J416, HCSS PWB.
• 11C-170 HCSS BM Power Distribution RAP.
Install new components as necessary:
• HCSS PWB, PL 11.92 Item 5.
• Bin 1 offset motor, PL 11.78 Item 6.
Enter dC330, code 11-337, actuate the Bin 1 offset sensor, Q11-337, Figure 1. The
changes.
Y N
Go to Flag 1. Check the sensor Q11-337.
Refer to:
• GP 11, How to Check a Sensor.
• P/J416, HCSS PWB.
• 11C-170 HCSS BM Power Distribution RAP.
Install new components as necessary:
• HCSS PWB, PL 11.92 Item 5.
• Bin 1 offset sensor, PL 11.78 Item 7.
Perform SCP 6 Final Actions.
Status Indicator RAPs
11-031-170, 11-337-170
display
August 2007
2-452
Bin 1 offset sensor,
Q11-337
Bin 1 offset motor,
MOT11-034
Figure 1 Component location
WorkCentre 5687 Family