Hole Punch Jam Rap - Xerox WorkCentre 5687 Series Service Manual

11-110-130 Hole Punch Jam RAP

11-110-130 A sheet is late arriving at the punch position sensor.
Initial Actions
• Check the hole punch motor coupling, PL 11.36 Item 11.
• Remove the hole punch unit, check that the hole punch mechanism is free to rotate and is
clear of any jammed material.
Procedure
Enter dC330, code 11-110. Actuate the punch position sensor, Q11-110, Figure 1. The
play changes.
Y N
Go to Flag 1. Check the sensor Q11-110.
Refer to:
• GP 11, How to Check a Sensor.
• P/J420, HCSS PWB.
• 11C-130 HCSS Power Distribution RAP.
Install new components as necessary:
• Punch position sensor, PL 11.38 Item 9.
• HCSS PWB, PL 11.56 Item 5.
Enter dC330, code 11-348. Actuate the chad bin level sensor, Q11-348, Figure 1.
NOTE: The chad bin collects the pieces of paper (chad) cut out by the punch. The chad bin
must be correctly installed for the chad bin level sensor to operate.
The display changes.
Y N
Go to Flag 2. Check the chad bin level sensor Q11-348.
Refer to:
• GP 11 How to Check a Sensor.
• P/J422, HCSS PWB.
• 11C-130 HCSS Power Distribution RAP.
Install new components as necessary.
• Chad bin level sensor, PL 11.36 Item 8.
• HCSS PWB, PL 11.56 Item 5.
Perform SCP 6 Final Actions.
Status Indicator RAPs
11-110-130
dis-
Figure 1 Component location
August 2007
2-402
Punch position
sensor, Q11-110
Chad bin level
sensor, Q11-348
WorkCentre 5687 Family