11-130-130, 11-132-130 Top Exit Jam RAP
11-130-130 The lead edge of a sheet is late arriving at the top exit sensor.
11-132-130 The trail edge of a sheet is late leaving the top exit sensor.
Initial Actions
Perform the following:
•
Clear any paper jam from the HCSS and the machine.
•
Check that the document guides are not damaged, PL 11.32 Item 4.
•
Check that the top exit sensor actuator is not trapped in the cover, Figure 1.
•
Check that the idler rolls in the exit cover have an even contact with the exit drive rolls,
Figure 1.
•
Open the exit cover assembly, PL 11.32 Item 1. Check the ribs on the underside of the
exit cover assembly for glue residue. If necessary, use a micro fibre wipe, PL 26.10 Item
13 dampened with film remover, PL 26.10 Item 4 to clean the ribs.
Procedure
Enter dC330, code 11-330. Actuate the Bin 0 90% full sensor, Q11-313, Figure 1. The
play changes.
Y
N
Go to Flag 1. Check the sensor, Q11-313.
Refer to:
•
GP 11, How to Check a Sensor.
•
P/J422, HCSS PWB.
•
11C-130 HCSS Power Distribution RAP.
Install new components as necessary:
•
Bin 0 90% full sensor, PL 11.30 Item 13.
•
HCSS PWB, PL 11.56 Item 5.
Enter dC330, code 11-130. Actuate the top exit sensor, Q11-130, Figure 1. The
changes.
Y
N
Go to Flag 2. Check the sensor, Q11-130.
Refer to:
•
GP 11, How to Check a Sensor.
•
P/J422, HCSS PWB.
•
11C-130 HCSS Power Distribution RAP.
Install new components as necessary:
•
Top exit sensor, PL 11.32 Item 3.
•
HCSS PWB, PL 11.56 Item 5.
Enter dC330, code 11-002, to energise the diverter solenoid, SOL 11-002. The
energises.
Y
N
Go to Flag 3. Check the solenoid SOL 11-002.
A
Status Indicator RAPs
11-130-130, 11-132-130
A
Refer to:
•
GP 12 How to Check a Solenoid or Clutch.
•
P/J421, HCSS PWB.
•
11C-130 HCSS Power Distribution RAP.
Install new components as necessary.
•
Diverter gate solenoid, PL 11.36 Item 3.
•
HCSS PWB, PL 11.56 Item 5.
Enter dC330 output code11-000 to run the transport motor 1B, MOT 11-000, Figure 1. The
motor runs.
Y
N
Go to 11-120-130, 11-122-130 Compiler Carriage Jam RAP, check the transport motor
1B.
The top nip rolls are driven when MOT 11-000 runs.
Y
N
Check the transport motor 1B drive belt, PL 11.38 Item 3.
Perform SCP 6 Final Actions.
dis-
display
solenoid
August 2007
2-408
WorkCentre 5687 Family