SSANGYONG Rexton Y200 Manual page 1281

Hide thumbs Also See for Rexton Y200:

Table of Contents

5D2-86 TRANSFER CASE - TOD

44. Install upper and lower speed sensors into the

cover. Feed the coil wire through the upper speed

sensor wire shield.

45. Install upper tone wheel, speedometer gear and

rear output seal. Use Output Shaft Seal Replacer

and Driver or equivalent to install seal.

46. Coat the mating surface of the front case with a

bead of Black Non-Acid Cure Silicone Rubber or

47. The following procedure must be followed prior to

installing the rear case onto the front case half:

Align the output shaft with the rear case output

Align the helical cam with the rear case motor

If difficulty is encountered with seating the rear

case, tap the rear output shaft with a sharp blow

using a rubber mallet in a direction away from

the triangular shaft while pushing down on the

SSANGYONG Y200

Chapters

Table of Contents