Steering Gear Pump; Assembly Installation - SSANGYONG Rexton Y200 Manual

Hide thumbs Also See for Rexton Y200:

Table of Contents

6A-14 POWER STEERING

STEERING GEAR PUMP

1. Separate the drive belt from pump pulley after each

pipe and hose is removed.

2. Remove the bolts/nuts in pump and pull off the

pump assembly from engine.

1. Install the power steering pump in engine and

tighten the bolt/nut as specified torque.

2. Install the power steering gear box in frame.

Tighten the mounting bolts slightly and then install

the gear box clamp in left. Tighten the bolt/nut as

specified torque.

Notice: Because the length of bolt is same, install

them after checking.

Installation Notice

95 mm Bolt/Nut (Upper)

95 mm Bolt/Nut (Lower)

23 N•m (17 lb-ft)

23 N•m (17 lb-ft)

(52 - 66 lb-ft)

(52 - 66 lb-in)

SSANGYONG Y200

Table of Contents