SSANGYONG Rexton Y200 Manual page 1272

SSANGYONG Y200
TRANSFER CASE - TOD 5D2-77
8. Disconnect front and rear speed sensor as
needed.
9. Remove the 17 bolts that retain the front case to
the rear case.
YAD5D400
10. Make sure that the front case is facing downward
so that the rear cover is facing upwards.
11. Remove the rear front case from the rear case.
12. Remove all traces of gasket sealant from the
mating surfaces of the front case and rear case.
13. If the speedometer drive gear is to be replaced,
first remove the flange seal by prying and pulling
the curved-up lip of the flange seal.
Notice: Be careful not to damage the bearing,
bearing cage or case. Remove and discard the
flange seal.
14. Remove the speedometer drive gear and upper
YAD5D410
tone wheel.
15. If the rear output shaft bearing requires replacing,
remove the internal snap ring that retains the
bearing in the bore.
16. From the outside of the case, drive out the bearing
using the driver.
17. Remove the three nuts and washers retaining the
clutch coil assembly to the rear case.
18. Pull the assembly, along with the O-ring and wire,
from the case.
YAD5D420