SSANGYONG Rexton Y200 Manual page 1275

5D2-80 TRANSFER CASE - TOD
43. If replacement of the needle bearing and bushing
is required, press the bearing and bushing is
required, press the bearing and bushing out as
follows:
•
Position the input shaft on Axle Bearing/Seal
plate, and using Pinion Bearing Cone Replacer
as a spacer.
•
Insert Input Shaft Bearing Remover into the input
shaft so it is resting on top of the bearing cage.
•
Tighten the actuator pin until it stops, then press
the bearing and bushing out together.
YAD5D500
44. If required, remove the front yoke to flange seal
by prying and pulling on the curved-up lip of the
yoke to flange seal.
Notice: Be careful not to damage the bearing,
bearing cage or case.
45. If required, remove the internal snap ring retaining
the front output shaft ball bearing and remove the
bearing.
YAD5D510
Assembly Procedure
1. Before assembly, lubricate all parts with Automatic
Transmission Fluid or equivalent.
2. If removed, drive the bearing into the front output
case bore.
Notice: Drive the bearing in straight, making sure
it is not cocked in the bore.
3. Install the internal snap ring that retains the bearing
to the front case.
4. If removed, install the front yoke to flange seal in
the front case bore.
5. If removed, install the yoke to flange seal into the
mounting adapter bore.
YAD5D520
SSANGYONG Y200