SSANGYONG Rexton Y200 Manual page 1279

5D2-84 TRANSFER CASE - TOD
28. Install apply cam onto the rear output shaft,
29. Install three balls into the apply cam.
30. Install cam and coil housing assembly onto rear
output shaft.
31. Install thrust bearing assembly onto output shaft.
YAD5D650
32. If removed, drive the front output shaft ball bearing
into the rear cover bore with Front Shaft Needle
Bearing Replacer and Driver Handle.
YAD5D660
33. If removed, install the rear output bearing in the
rear case bore. Drive the bearing into the rear
case bore with Output Shaft Bearing Replacer and
Driver Handle. Make sure that the bearing is not
cocked in the bore.
34. Install the internal snap ring that retains the bearing
to the rear case.
YAD5D670
35. Install the clutch coil from inside the rear case until
the wire and studs extend through the cover.
Notice: Do not kink or trap the wire while seating
the clutch coil to the case.
36. Install the washers and nuts and tighten.
Installation Notice
Tightening Torque
YAD5D680
8 - 11 N•m
(71 - 97 lb-in)
SSANGYONG Y200